WhatsApp: +86 17867875568

Operating Procedures For Stainless Steel Cable Tie Tools

Publish Time: Author: Site Editor Visit: 63

Stainless Steel Cable Tie is mainly used to bundle various items. The cable tie has good corrosion resistance and strong binding force. In addition, the bundled products are not restricted by shape and size, so it is a good replacement for traditional binding methods. Using tools can make the binding effect of cable ties better. Here is an introduction to the operating procedures of cable tie tools.

1. Pass the cable tie through the buckle. Note that the buckle opening should be upward and the end of the cable tie should be opposite to the operator, otherwise it is easy to poke the operator.

2. Pass the cable tie through the buckle from the top of the item, and then let the cable tie wrap around the product. In this way, the cable tie will return to the bottom of the item. You can determine one or more wraps according to the situation of the item.

3. Pass the cable tie through the buckle again so that a loop can be formed. The end of the cable tie should extend about 6 cm from the buckle.

4. Bend the end of the cable tie downward so that the end is between the cable tie and the item.

5. Tighten the cable tie around the item to ensure that the buckle and the item fit tightly to prevent the items from being too loose and falling apart.

6. Use your left hand to hold the tool and ensure that the front opening and the ratchet slot are in the same straight line.

7. Pass the cable tie through the opening and the ratchet slot to ensure that the cutting lock block is in the locked position

8. Hold the cutting handle with your right hand, tighten the handle with your left hand, and move it back and forth appropriately to tighten the cable tie.

9. If the bundle is too tight and you want to tie it tighter, you can tighten the cable tie further.

10. Then pull the tightening handle back to its original position.

11. Use your left hand to hold the two handles and turn them clockwise.

12. Open the cutting lock module, hold the tightening handle with your left hand, and hold the cutting handle with your right hand, and press the cutting handle hard to cut the cable tie.

13. When the cable tie is cut, you can remove the tool.

14. Use a hammer to knock the buckle ears inward to avoid exposing the buckle ears and affecting the appearance.

After reading this, do you think the operation procedures of stainless steel cable tie tools are simple? Cable ties can be used to classify and store items well, so the corresponding tools have also attracted people's attention.

Operating Procedures For Stainless Steel Cable Tie Tools

This site uses cookies

We use cookies to collect information about how you use this site. We use this information to make the website work as well as possible and improve our services.